Some Troubleshooting the Scanner
Troubleshooting 1:At the time of connecting the computer to the scaner to show the error message "Access scanner failed" or "scanner not found" that thwart the process of scanning to be performed.
Solution:
scanner that the cause is not yet connected to the computer hardware. Scanners that have not connected this hardware could have caused the SCSI-Interface card is not installed correctly. If the SCSI cable is not really well connected, it will disrupt the relationship between the scanner and card. Turn off the computer and check the cord connection.
It should also be remembered that at the time of computer, scanner devices must be turned on first before dinyalahkan computer.
Troubleshooting 2;
Computers can be connected to the scanner. But when doing a scan process, suddenly the process stopped and an error message appears "not Enough memory".
Solution:
usually occurs because the rest of your hard disk space is very small. Try using disk utility to add the rest of the space. Or by scanning the image again at a lower level of dpi, and at a lower color depth also, for example, grayscale or black.
Troubleshooting 3;
scanning process was not started soon. After berjalanpun process was very slow.
Solution:
If that happens, do the checks as follows:
- Trying to do checks on the source document to be scanned. Make sure the automatic closing penapang has been closed tightly.
- Another thing to also note is that a cable connection, whether the conditions are still good. Each end and the base is already well embedded. Troubleshooting 4;
After the scan process is executed, it scans the image results are not satisfactory. Picture looks cracked and there are patches that contaminates the image.
Solutions:
The first analysis of damage to the image, could have been caused by a fungus in the scanner glass. To overcome this glass clean inside and out regularly with a liquid cleanser, which many chemicals are sold in stores.
If the image was cracked, the problem may be at a resolution of the image. Nothing wrong if you raise the resolution higher than previous figures. It usually takes a long time of scanning. To be more brief, you should limit the (crop) on the desired area only Each scanner must have the tools to perform these croop.
Troubleshooting 5;
Scan process runs smoothly, but the scanned image looks unclear and vague as affected by blur effect.
Solution:
If the scanned image is blurred, you try to set displaynya Hight resolution color (16 bit), and allow the scanner to warm up (warming up) for several minutes. Noteworthy is the cleanliness of the glass surface, because if dirty clean can affect whether or not the scan results later. Make sure the glass is always clean. Clean with a soft cloth.
Troubleshooting 6;
different quality of the scanned images on multiple computers
solutions:
Differences in image quality can arise because of differences in VGA quality at each computer. The photo will look good when you use a computer with high VGA (minimum 32 Mb). Instead, the image will appear broken when you see him use a computer with a mediocre VGA (under 32 MB). Actually the quality of images generated from the scanner is the same or unchanged. Just look at the monitor (VGA computer with low), which makes the image as if it were damaged.
Subscribe to:
Post Comments (Atom)
sponsor link
YM
No comments:
Post a Comment